3. Disassembly and Reassembly
3-4 Replacement of Fuse
Parts
Fuse
3-5 Replacement of Drive Motor
Parts
Drive
Motor
Explaination Photo
Explaination Photo
The fuse is located on the noise filter.
1. Disconnect power and remove grille .
2. Replace the fuse .
3. When 20A fuse blows out by the operation
of interlock monitor switch failure, replace
the primary interlock switch, secondary
interlock switch, door sensing switch,
interlock monitor switch and power relay .
4. When the above four switches operate
properly, check if any other part such as the
control circuit board, blower motor or high
voltage transformer is defective .
1. Disconnect power and remove bottom plate
screws(5) .
2. Remove bottom plate and disconnect the
turntable motor drive .
3. Remove turntable motor screws(1) and pull
the turntable motor out .
4. When replacing the drive motor, be sure to
remount it in the correct position with the
coupler .
5. Connect all the leads to the drive motor .
13
Explaination
Explaination