Husqvarna yth24v54 Operator's Manual page 17

M NTENANCE
EVERY EVERY EVERY EVERY
8 25 50 100
SCHEDULE HouRs HOURS HOURS HOURS
Check Brake Operation
Check Tire Pressure
Check
Operator
Presence & ROS
Systems
A
Check for Loose Fasteners
C Check/Replace
Mower Blades
T
Lubrication Chart
0 Check Battery
Lever
R CRean Battery
and Terminals
CRean Debris Off
Steering
Plate
Check Transaxle
Cooling
Check Mower Levehess
Check VoBelts
Check Engine OH Lever
Change Engine OH (modeRs with oH filter)
Change Engine Oil ImodeRs without oil filter)
N_ CRean Air FHter
G CRean Air Screen
! Inspect Muffler/Spark Arrester
N Replace OHFHter(If equipped)
E Clean Engine
Cooling Fins
Replace Spark Plug
Replace
Air Filter
Paper Cartridge
Replace Fuel Filter
1 - Change more often when operating under a heavy load or inhigh ambient temperatures
2 - Service more often when operating in dirty or dusty conditions.
BEFORE
EACH
USE
J
J
v'
l
J4
_1,2
J
_1,2
3 - Replace blades more often when mowing in sandy soil
4 - Not required if equipped with maintenance-free battery.
v'
_2
EVERY BEFORE
SEASON STORAGE
J
5 - See Cleaning in Maintenance Section.
GENERAL RECOMMENDATIONS
The warranty on this tractor does not cover items that have
been subjected to operator abuse or negligence. To receive
full value from the warranty, operator must maintain tractor
as instructed in this manual.
Some adjustments will need to be made periodically to
properly maintain your tractor.
At least once a season, check to see if you should make
any of the adjustments described in the Service and
Adjustments section of this manual.
At least once a year you should replace the spark plug,
clean or replace air filter, and check blades and berets
for wear. A new spark plug and clean air filter ensure
proper air-fuel mixture and help your engine run better
and last longer.
LUBRmCAT_ON CHART
_._ SPINDLE ZERK-
_._ FRONT
WHEEL
BEARING
ZERK
0b
SECTOR
GEAR
TEETH
SPINDLE ZERK
FRONT
WHEEL
BEARING
ZERK
ENGINE
MANDREL
ZERKS
BEFORE EACH USE
Check engine oil level.
o Check brake operation.
o Check tire pressure.
o Check operator presence and ROS systems for proper
operation.
Check for loose fasteners.
02501
(_ General Purpose Grease
Refer to Maintenance "ENGINE" Section
17
IMPORTANT: DO NOT OIL OR GREASE THE PIVOT POINTS
WHICH HAVE SPECIAL NYLON BEARINGS. VISCOUS
LUBRICANTS WILL ATTRACT DUST AND DIRT THAT WILL
SHORTEN THE LIFE OFTHE SELF-LUBRICATING BEARINGS.
IF YOU FEEL THEY MUST BE LUBRICATED, USE ONLY A
DRY, POWDERED GRAPHITE TYPE LUBRICANT SPARINGLY.