Shark S3501 Series Owner's Manual page 10

Hide thumbs Also See for S3501 Series:

Using Your Steam Mop - cont'd

For your comfort, you can adjust the height of the

mop. Just lift the latch on the tube 90 degrees to the

open position. Holding the handle, extend the tube

to the height that's right for you and then close the

latch to the locked position.

When one side of the cleaning pocket gets dirty, just

flip the mop head and you can quickly start using

the other side. Dirt can't hide on either side. Use the

cleaning pockets with the scrubbing strip (P129W or

P140W) to clean very dirty areas.

IMPORTANT: Please wait 3-5 minutes for the

Steam Mop to cool off before switching the mop

head or the cleaning pockets.

TOLL FREE: 1-800-798-7398

When the water tank is empty, the steam mop will

stop producing steam. You can refill the water tank

at any time as long as the mop is unplugged from

the outlet. Follow the instructions from page 4.

This goes for switching the mop heads or cleaning

pockets as well.

IMPORTANT: Never leave the steam mop with a

damp/wet cleaning pocket on any floor surface for

any amount of time as this may damage the floor.

Table of Contents

Show Quick Links