Epson WF-2510 Basic Manual page 19

Basic Guide
Monochrome 2-line display models
Error Messages
Paper jam
Press OK. If the error does not clear, remove the paper by
hand.
Paper jam in the ADF. Remove the jammed paper.
Communication error. Make sure the cable is connected,
then try again.
Printer error
Paper jam. Open the scanner unit and remove the paper,
then turn off the printer. See your documentation.
ADF Error.
Remove any objects or documents inside ADF. Turn power
off. See documentation.
Printer error
See your documentation.
Scanner error
See your documentation.
A fax error has occurred.
See your documentation.
A printer's ink pad is nearing the end of its service life.
Please contact Epson Support.
A printer's ink pad is at the end of its service life. Please
contact Epson Support.
No dial tone.
Fax job incomplete.
Recovery Mode
Basic Troubleshooting
Solutions
Remove the jammed paper.
& "Paper Jams" on page 18
Make sure the computer is connected correctly. If the error
messages still appears, make sure that scanning software is
installed on your computer and that the software settings are
correct.
Turn the product off and then back on. Make sure that no paper is
still in the product. If the error message still appears, contact Epson
support.
Turn the product off and then back on. If the error message still
appears, contact Epson support.
Press OK to resume printing. The message will be displayed until
the ink pad is replaced.
Contact Epson support to replace ink pads before the end of their
service life. When the ink pads are saturated, the product stops and
Epson support is required to continue printing.
Contact Epson support to replace the ink pad.
Make sure the phone cable is connected correctly and the phone
line works.
& "Connecting to a Phone Line" on page 9
If you connected the product to a PBX (Private Branch Exchange)
phone line or Terminal Adapter, turn off the Dial Tone
Detection.
& Press K and then x. Then select Fax Settings >
Communication > Dial Tone Detection.
The firmware update has failed. You will need to re-attempt the
firmware update. Ready a USB cable and visit your local Epson
website for further instructions.
17