Storage; Cleaning And Storing The Machine - Toro Z Master Professional 6000 74922 Operator's Manual

Storage

Cleaning and Storing the
Machine
1. Disengage the power-take off (blade-control switch
(PTO), set the parking brake, and turn the ignition key
to the Off position, and remove the key.
2. Remove grass clippings, dirt, and grime from the
external parts of the entire machine (especially the
engine and hydraulic system). Clean dirt and chaff
from the outside of the engine-cylinder-head fins and
the blower housing.
Important: You can wash the machine with mild
detergent and water. Do not pressure wash the
machine. Avoid excessive use of water, especially
near the control panel, engine, hydraulic pumps,
and motors.
3. Check the brake; refer to
(page 50).
4. Service the air cleaner; refer to
Cleaner (page 36).
5. Grease the machine; refer to
6. Change the crankcase oil; refer to
Oil (page 37).
7. Check the tire pressure; refer to
Pressure (page 45).
8. Change the hydraulic filters; refer to
Hydraulic System (page
9. Charge the battery; refer to
42).
10. Scrape any heavy buildup of grass and dirt from the
underside of the mower, then wash the mower with
a garden hose.
Note: Run the machine with the blade-control switch
(PTO) engaged and the engine at high idle for 2 to
5 minutes after washing.
11. Check the condition of the blades; refer to
the Cutting Blades (page
12. Prepare the machine for storage when non-use occurs
over 30 days. Prepare the machine for storage as
follows:
A. Add a petroleum based stabilizer/conditioner to
fuel in the tank. Follow mixing instructions from
the stabilizer manufacturer. Do not use an alcohol
based stabilizer (ethanol or methanol).
Note: A fuel stabilizer/conditioner is most
effective when mixed with fresh fuel and used at
all times.
B. Run the engine to distribute conditioned fuel
through the fuel system (5 minutes).
Adjusting the Parking Brake
Servicing the Air
Lubrication (page 34).
Servicing the Engine
Checking the Tire
Servicing the
56).
Servicing the Battery (page
Servicing
60).
C. Stop the engine, allow it to cool, and drain the fuel
tank; refer to
D. Restart the engine and run it until it stops.
E. Dispose of fuel properly. Recycle as per local
codes.
Important: Do not store
stabilizer/conditioned fuel over 90 days.
13. Check and tighten all bolts, nuts, and screws. Repair or
replace any part that is damaged.
14. Paint all scratched or bare metal surfaces. Paint is
available from your Authorized Service Dealer.
15. Store the machine in a clean, dry garage or storage area.
Remove the key from the ignition switch and keep it
out of reach of children or other unauthorized users.
Cover the machine to protect it and keep it clean.
65
Servicing the Fuel Tank (page 42).