Makita BTP141 Instruction Manual page 7

Changing the impact force
(impact driver mode " ")
2
3
4
1. Changed in three steps
2. Hard
3. Medium
4. Soft
5. Control button
012244
Impact force grade
displayed on panel
Hard
Medium
Soft
012243
The impact force can be changed in three steps: hard,
medium and soft.
This allows a tightening suitable to the work.
Every time the button
grade changes in three steps.
For approximately one minute after releasing the switch
trigger, the impact force can be changed.
1
5
Maximum blows
BTP131 BTP141
3,200
3,200
-1
-1
(min )
(min )
2,400
2,400
-1
-1
(min )
(min )
1,200
1,200
-1
-1
(min )
(min )
is pressed, the impact force
Application
Tightening when force
and speed are desired.
Tightening when a good
finishing is needed.
Tightening when excessive
tightening need to be avoided
because of potentially clogged
female screw and broken or
damaged screw head.
NOTE:
During the operation of switch trigger, the impact force
grade cannot be changed.
7
Work
Tightening in underwork
material/ Tightening long
screws/ Tightening bolts.
Tightening in the finishing
board, plaster board.
Tightening sash screw/
Tightening small screws
such as M6.