Attaching The Hose - Husky C302H Use And Care Manual

Pre-Operation (continued)

ATTACHING THE HOSE

WARNING: Do not attempt to modify this product or
create accessories not recommended for use with this
product. Any such alteration or modification is misuse and
could result in a hazardous condition leading to possible
serious personal injury.
WARNING: Do not attach the air chuck or other tools
to the open end of the hose until start-up has been
completed.
WARNING: Do not allow familiarity with products to
make you careless. Remember that a careless fraction of
a second is sufficient to inflict serious injury.
WARNING: Always wear safety goggles or safety
glasses with side shields when operating power tools.
Failure to do so could result in objects being thrown into
your eyes resulting in possible serious injury.
The compressor is assembled at the factory and ready for
use. Check all components to ensure secure assembly.
(such as: rubber feet, wheels, handle, quick connects,
gages, safety valve, air filter, drain valve, etc.)
□
Make sure the power to the air compressor is
disconnected.
□
Apply thread tape to the threaded connections
of the hose (not included), and attach the quick
coupler to the hose using a wrench (not included).
□
Apply the thread tape to the threaded connections
of the male plug, and attach the male plug to the
hose using a wrench.
□
Rotate the pressure regulator knob (1) fully
counterclockwise.
□
Insert the hose adapter end of the air hose (2) into
the female coupler end in the air compressor (3).
C302H_HUSKY_manual_5-15-ENG.indd 12
1
3
12
2
6/10/15 12:05 PM