Installing The Relay Box - Panasonic VL-SVN511 series Installation Manual

2-2 How to make wiring connections
While pressing on the button (F) with a
pointed object such as a screwdriver, insert
the wire into the terminal connector (G). (To
disconnect a wire, while pressing on the
Button (F), pull out the wire.)
G
H
I
H Bare wire at tip 9mm
I Wiring from doorphone
Important:
Do not connect the power cable.
(Damage may occur.)
3
Mount the main monitor to the mounting
bracket.
3-1 Line up the tab on the bottom of the
bracket with the groove on the main monitor.
3-2 Line up the tab on the top of the bracket
with the groove on the main monitor, and push
the main monitor down until it is secure.
14
F

Installing the relay box

Wiring when you connect the main monitor cable
and electric lock using relay box
A
A 9 mm B 25 mm C 7 mm
Front view
4
1 2
R1 R2 R3
Relay box (with cable cover removed)
Top view
j
L Cable binder hole
1
Strip the cables from main monitor (A) and
cable from electric lock (B, C)
2
Remove the screw (D) and then remove the
cable cover (E).
3
Connect the cables from the electric lock (F,
G: if 2 electric locks are connected) to the
electric lock terminal (J) on the top of the
relay box and then secure the wires by
tightening the screws (I).
R Recommended torque: 0.45 N·m
{4.6 kgf·cm}
4
Use the cable binder (H) (accessory) to
secure the cables from electric lock (F, G)
(double-coated area) to the relay box.
5
Make sure to replace the cable cover (E).
6
While pressing on the button with a pointed
object such as a screwdriver, insert the cable
from main monitor (K) into the main monitor
terminal connector (M). (To disconnect a
cable while pressing on the button, pull out the
cable.)
When installing on a wall
For more information, refer to "Attach to the DIN
rail" (page 11) and "Wall mounting" (page 12).
B
C
6 7 8
5
S1 S2 S3 S4
1 2
9
1 2
R1 R2 R3 button
k
Bottom view
l
m