Before Requesting Services - Teac DV223 User Manual

Before Requesting Service
Check the following guide for the possible cause of a problem before contacting service.
Symptom
No power
No picture
NO sound
The playback picture is poor
The DVD player does not start playback
Severe hum or noise is heard.
The remote control does not work properly.
Completely distorted picture or no colour
The icon appears on screen
Correction
Plug the power cord into the wall outlet securely.
z
Select the appropriate video input mode on the TV so
picture from the DVD player appears on the TV screen.
z
Connect the video cable into the jacks securely.
z
Turn on the TV
z
Check audio connections.
z
If you are using a HiFi amplifier, try another sound source.
z
Clean the disc.
z
Correct the TV / DVD player colour system.
z
Insert a disc, if no disc inside the player.
z
Insert a playable disc. (Check the disc type and color system
z
Place the disc with the playback side down.
z
Clean the disc.
z
Cancel the Rating function or change the rating level.
z
Wipe them with a cloth slightly moistened with alcohol.
z
Clean the disc
z
Connect the speakers and components securely.
z
Move your TV away from the audio components.
z
Point the remote control at the remote sensor of the DVD
receiver.
z
Operate the remote control within about 5m.
z
Remove the obstacle.
z
Replace the batteries with new ones.
If the picture is distorted completely or if the picture rolls vertically,
make sure the NTSC/PAL setting at the DVD player matches the
colour system of your television.
z
The DVD's software restricts it.
z
The DVD's software doesn't support the feature (eg., angles).
z
The feature is not available at the moment.
16
the