Dyna-Glo DGPH201BR Owner's Manual page 14

OPERATION INSTRUCTIONS
5. Push the electronic ignitor button until pilot flame is visible through viewing hole.
6. Once the pilot is lit, continue to depress the control knob for 30 seconds.
7. If the pilot does not stay lit, repeat steps 4 to 6.
8. If after repeating steps 4 to 6 unit does not light, then
-Push in control knob and turn counterclockwise to "PILOT" (
-As you are depressing the control knob, place long stem lighter (not included)
into the viewing hole on the head assembly to light the pilot (Figure 4).
-Repeat step 6.
Figure 3
9. Push in and turn the control knob to the "LOW"(
control knob. If you want a higher temperature, push in the control knob
and turn counterclockwise to the "HIGH" (
Note: If pilot fails to remain lit, all valves should be closed and a waiting
period of at least 5 minutes should pass before attempting to light.
Normal
If you experience any ignition problem please consult "Troubleshooting" on page 18.
Caution: Avoid inhaling fumes emitted from the heater's first use. Smoke and odor from the burning
of oils used in manufacturing will appear. Both smoke and odor will dissipate after approximately 30
minutes. The heater should NOT produce thick black smoke.
Note: The burner may be noisy when initially turned on. To eliminate excessive noise from the burner,
turn the control knob to the PILOT position. Then, turn the knob to the level of heat desired.
When heater is ON:
Emitter screen will become bright red due to intense heat. The color is more visible at night. Burner
will display tongues of blue and yellow flame. These flames should not be yellow or produce thick
black smoke, indicating an obstruction of airflow through the burners. The flame should be blue with
straight yellow tops. If excessive yellow flame is detected, turn off heater and consult "Troubleshooting"
on page 18.
in.
in.
in.
Abnormal
Figure 4
), then release
) (Figure 5).
in.
in.
in.
14
) (Figure 3).
Figure 5