Husqvarna AUTOMOWER 315 Operator's Manual page 33

If the guide wire has to be installed on a steep
slope, it is an advantage to lay the wire at an
angle to the slope. This makes it easier for the
robotic lawnmower to follow the guide wire on
the slope.
Avoid laying the wire at sharp angles. This can
make it difficult for the robotic lawnmower to follow
the guide wire.
6. Run the guide wire to the point on the boundary
loop where the guide wire is to be connected.
Lift up the boundary wire. Cut the boundary
wire using for instance a pair of wire cutters.
Connecting the guide wire is made easier if an
eyelet has been made on the boundary wire as
outlined in the previous description. See Eyelet for
connecting the guide wire on page 26.
7. Connect the guide wire to the boundary wire using
a coupler:
Insert the boundary wire and guide wire in the
coupler. Check that the wires are fully inserted
into the coupler so that the ends are visible
through the transparent area on the other side of
the coupler.
Use a polygrip to completely compress the button
on the coupler.
It does not matter which holes are used to
connect each wire.
8. Staple down/bury the splice in the lawn.
IMPORTANT INFORMATION
The guide wire may not cross the bound-
ary wire, for instance a boundary wire that
is laid out to an island.
OM_1157863-26_HQ 310,315,EN_160229.indd 31
INSTALLATION
3018-061
135º
135º
90º
3012-1327
3023-015
3018-1323
3023-016
English - 31
2016-02-29 10:51:54