Device Backup; Device Information; Initialize - Yamaha PX10 Reference Manual

 DEVICE BACKUP
(Advanced mode only)
Save and restore all the settings in a PX amplifier to/from a USB flash drive. Use the func-
tion when you want to set multiple PX amplifiers to the same setting, or change to another
PX amplifier and keep the same settings.
q
w
WARNING
If a speaker type different from the current one is recalled, the volume will change signifi-
cantly. Carry this out with the volume lowered for safety.
q SAVE TO USB
Saves all the setting data in the device to a USB flash drive.
w RESTORE FROM USB
Restores setting data stored in a USB flash drive.
NOTE
The PX10/PX8 cannot recall settings stored on the PX5/PX3 in the Power Boost mode.
 DEVICE INFORMATION
Indicates the internal status of the PX amplifier.
q
w
e
r
q THERMAL PSU
Indicates the temperature of the power supply unit in three grades. If maximum is indi-
cated, the limiter is active.
w THERMAL AMP
Indicates the temperature of the amplifier unit in five grades. The limiter is active
depending on the temperature.
e RUN TIME
Indicates the total operating time of the device.
r FIRMWARE
Indicates the version of the firmware.
 INITIALIZE
Indicates how to initialize the internal data of the PX amplifier.
NOTE
Refer to "Initializing the PX amplifier" (page 35)
Panel Operation — UTILITY screen
for instructions on initializing.
PX10/PX8/PX5/PX3 Reference Manual
34