Removing Change Lever; Installing Change Lever - Makita HR5001C Technical Information

•Removing Change lever(same as HR4000C)
a. Set the change lever at neutral position, and slightly
hit the back side of the lock button using the resin
hammer to remove it.(See the figure 1.)
•Installing Change lever (same as HR4000C)
a. Adjust Change link.(See the figure 2.)
to position the hole for Crank pin4 of Change lever.
b. Insert Crank pin 4 of the change lever into the
hole of Change link. (See the figure 3)
Note 1) Change lever should at the position of hammering-mode.
Note 2) Do not start the tool while the Change lever is not installed.
It may potentially lock and damage the parts inside the tool.
Change link
Figure 2
Hole of the Change link
Change lever
Neutral position
Hammering-mode
Change lever
Figure 3
Resin hammer
Lock button
Figure 1
(Crank pin 4 position)