■
Changing the door unlock function setting
It is possible to set which doors the entry function unlocks using the wireless remote con-
trol.
Turn the "START STOP ENGINE" switch off.
1
When the indicator light on the key surface is not on, press and hold
2
or
for approximately 5 seconds while pressing and holding
The setting changes each time an operation is performed, as shown below. (When
changing the setting continuously, release the buttons, wait for at least 5 seconds, and
repeat step
2
Multi-information
display
To prevent unintended triggering of the alarm, unlock the doors using the wireless
remote control and open and close a door once after the settings have been changed. (If
a door is not opened within 60 seconds after
again and the alarm will automatically be set.)
In case that the alarm is triggered, immediately stop the alarm. (P.18)
For details on what to do when the electronic key does not operate properly, see page 108.
17
ES350_QG_OM33B49U_(U)
.)
Unlocking function
Holding the driver' s door han-
dle unlocks only the driver' s
door.
Holding a passenger' s door
handle unlocks all the doors.
Holding a door handle unlocks
all the doors.
.
Beep
Exterior: Beeps 3 times
Interior: Pings once
Exterior: Beeps twice
Interior: Pings once
is pressed, the doors will be locked
,