Electronic Journal Reports - Olivetti ECR7700 Plus SD User Manual

Electronic Journal Reports

An electronic journal report executed with the control key
in the X1/X2 position does not clear the electronic journal
memory (and therefore all transaction data are retained)
while the report executed with the control key in the
Z1/Z2 position cancels electronic journal memory thus
restoring it to its maximum line capacity programmed.
To momentarily interrupt report printing, press
this key again to resume printing.
To cancel report printing, press
Complete Electronic Journal Report
This report is a complete listing of transaction receipts and
Z financial reports taken within the maximum line capacity
programmed.
1. Control key position: X1/X2 or Z1/Z2. Bear in mind that
in the Z position the electronic journal memory contents
are cleared after you press
plenty of paper loaded in the printer.
2. If a manager password was defined type the
[4-digit password] and press
3. Press .
When the contents of the electronic journal are printed, a
message is displayed along with a beep to indicate that the
EJ memory capacity has been restored to its programmed
line capacity.
18
. Press
.
. Make sure there is
.
Oldest Transaction Report
By entering the number of transactions you wish to view,
this report prints the selected number of oldest receipts and
Z financial reports performed and stored within the
programmed line capacity.
1. Control key position: X1/X2 or Z1/Z2. Bear in mind that
in the Z position the journal report contents are cleared.
Make sure there is plenty of paper loaded in the printer.
2. If a manager password was defined type the
[4-digit password] and press
3. Type a number between [001 and 999] indicating the
number of oldest reports wanted and press
Latest Transaction Report
By entering the number of transactions you wish to view,
this report prints the most recent receipts and Z financial
reports performed and stored within the programmed line
capacity.
1. Control key position: X1/X2 or Z1/Z2. Bear in mind that
in the Z position the journal report contents are cleared.
Make sure there is plenty of paper loaded in the printer.
2. If a manager password was defined type the
[4-digit password] and press
3. Type a number between [001 and 999] indicating the
number of latest reports wanted and press
Daily Report
By entering the number of Z financial reports that you wish
to view, this report prints the receipts recorded before the
defined Z financial report along with the report itself.
1. Control key position: X1/X2 or Z1/Z2. Bear in mind
that in the Z position the journal report contents are
cleared. Make sure there is plenty of paper loaded in
the printer.
2. If a manager password was defined type the
[4-digit password] and press
3. Type a number between [01 and 99] indicating the
number of oldest end-of-day reports wanted and press
.
.
.
.
.
.