Rear Panel - Onkyo TX-RZ710 Basic Manual

> Before start > Hookup

Rear Panel

1 2
11
1. DIGITAL IN OPTICAL/COAXIAL jacks: Input TV or AV
component digital audio signals with a digital optical
cable or digital coaxial cable.
2. TUNER AM/FM 75Ω terminal: The supplied antennas
are connected.
3. VIDEO IN jacks: Input the video signals from AV
component with an analog video cable.
4. USB port: A USB storage device is connected so that
music files stored in it can be played. You can also
supply power (maximum 5V/1A) to USB devices with a
USB cable.
5. ETHERNET port: Connect to the network with an
Ethernet cable.
6. COMPONENT VIDEO IN jacks: Input the video signals
from AV components with a component video cable.
28
> Setup
3 4 5 6 7
12 13
7. HDMI OUT jacks: Transmit video signals and audio
signals with a HDMI cable connected to a monitor such
as a TV or projector.
8. HDMI IN jacks: Transmit video signals and audio signals
with a HDMI cable connected to an AV component.
9. Wireless antenna: Used for Wi-Fi connection or when
using a BLUETOOTH enabled device. Adjust their
angles according to the connection status.
10.AC INLET (North American, European and Asian
models): The supplied power cord is connected.
Power cord (Australian models)
11. GND terminal: The ground wire of the turntable is connected.
12.AUDIO IN jacks: Input TV or AV component audio
signals with an analog audio cable.
13.SPEAKERS terminals: Connect speakers with speaker cables.
> Playback > Part Names
8 9
14 15
10
16 17 18
You can connect the multichannel speakers for the main room
and the speakers for a separate room (ZONE 2). (North
American models are compatible with banana plugs.)
14.ZONE 2 PRE/LINE OUT jack: Output audio signals with
an analog audio cable to a pre-main amplifier or power
amplifier in a separate room (ZONE 2). (
15.SUBWOOFER PRE OUT jack: Connect a powered
subwoofer with a subwoofer cable. Up to two powered
subwoofers can be connected. The same signal is output
from each of the SUBWOOFER PRE OUT jacks.
16.12V TRIGGER OUT jack: Allows you to connect a device
with 12V trigger input jack to enable link operation
between the device and the unit.
17.IR IN jack: Allows you to connect a multiroom remote control kit.
18.RS232 port: For connection to the home control system.
9
90°
180°
P17)
