Blaupunkt St. Louis MP56 Operating And Installation Instructions page 43

•
for passengers in the front
and rear – at the head level
in the center of the vehicle.
➔
Ensure that all passengers in
the vehicle are sitting and re-
maining quiet.
➔
Change to the "DEQ" menu
and call up one of the user-de-
fi ned equalizer settings ("EQ-1"
to "EQ-3") as described in the
preceding section.
➔
Open the "USER EQ ADJUST"
menu as described on page 42.
➔
Press the softkey
"AUTO") and follow the instruc-
tions on the display.
After a 5-second countdown,
you hear the test noise and
the main line
shows "SILENCE PLEASE" and
"ADJUSTING".
The automatic equalizer setting
fi nishes successfully if "AD-
JUSTMENT OK" appears on the
A
main line . The equalizer set-
ting is saved. Any previously
stored setting under this equal-
izer setting is overwritten. The
new setting can now be called
up under the corresponding
equalizer setting ("EQ-1" to
"EQ-3").
Changing basic settings in the settings menu
7
(next to
A intermittently
MANUAL:
As an alternative, you can manual-
ly create the equalizer setting
without measurement microphone.
In each of the six frequency bands,
you can select one specifi c indi-
vidual centre frequency and
fi nely adjust its level and quality
factor Q.
➔
Insert a CD with which you are
very familiar.
➔
Adjust bass, treble, balance,
and fader to zero.
➔
Open the "USER EQ ADJUST"
menu as described on page 42.
➔
Press the softkey
"MANUAL").
➔
First, select a frequency band
to be changed. First, change
the centre, then the treble, fol-
lowed by the bass.
•
"LOW1" to "2": To change the
bass (20 to 250 Hz).
•
"HIGH1" to "4": To change
the centre or treble (320 to
20,000 Hz).
The frequency spectrum is dis-
played. if you already changed
the level in another frequency
band, this change is visible in
the frequency spectrum. The
current centre frequency (Hz)
is highlighted.
<
(next to
43