How To Swing The Control Box To The Front - Mitsubishi Electric EHSC-VM2B Service Manual

DISASSEMBLY PROCEDURE

4. How to swing the control box to the front

(1) Remove the front panel. (Refer to Procedure 1.)
(2) Remove the control box cover. (Refer to Procedure 3.)
* If the screw of the control box bracket (R) and 2 screws
of the control box bracket (L) are removed, the control
box can be swung to the front without removing control
box cover.
(3) Remove the screw from the control box bracket (R) and
2 screws from the control box bracket (L).
(4) Remove the coated clamps.
(5) Disengage the control box bracket (R) from the right-
hand side panel and pull the control box. At this point,
lifting slightly and pulling the control box will swing the
control box to the front. (Photo 4-2)
Note: Remove the field wiring as necessary.
OCH532A
PHOTOS
Photo 4-1
Earth cable
Screw
Bracket
(L)
Screw
Coated clamps
* The photos shown are of the EHSC model.
Photo 4-2
Control box
70
Side panel
Screw
Bracket
(R)
Swing