Table of Contents
Advertisement
PROGRAMMING STEPS
Step 3 - Press the appropriate command on the original factory remote.
Step 4 - To test the captured IR command, install a flasher for the source component and press the TEST IR button.
The ENTER IR LED may flicker, blink, or be intermittently solid RED to reflect real-time IR activity during IR transmission
and then turn OFF again.
Step 5 - If the command fails to operate the source component, press the same Function Key you are programming.
The IR command is automatically erased.
If the command successfully operates the source component, continue programming.
Step 6 - You can continue programming other Function Keys for the same Master Key Page.
Repeat steps 2 through 5 until all IR commands have been programmed.
The ENTER IR LED turns OFF, and the KEY LED
blinks RED.
74
Advertisement
Table of Contents
