Makita HR4001C Instruction Manual page 4

ENGLISH (Original instructions)
1-1. Switch trigger
2-1. Switch lever
3-1. Adjusting dial
4-1. Change lever
4-2. Pointer
4-3. Lock button
5-1. Change lever
5-2. Pointer
5-3. Lock button
6-1. Change lever
6-2. Pointer
6-3. Lock button
7-1. Change lever
7-2. Pointer
7-3. Lock button
8-1. Change lever
8-2. Pointer
8-3. Lock button
9-1. Power-ON indicator lamp (green)
9-2. Service indicator lamp (red)
SPECIFICATIONS
Capacities
No load speed (min
Blows per minute
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for hammer drilling in brick, concrete
and stone as well as for chiselling work.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated and can, therefore, also be used from
sockets without earth wire.
Noise
The typical A-weighted noise level determined according
to EN60745:
Model HR4001C
Sound pressure level (L
Sound power level (L
Explanation of general view
11-1. Side handle
11-2. Clamp nut
12-1. Side grip
13-1. Bit shank
13-2. Bit grease
14-1. Bit
14-2. Chuck cover
15-1. Bit
15-2. Chuck cover
16-1. Change lever
16-2. Pointer
16-3. Lock button
17-1. Pointer
17-2. Change lever
17-3. Lock button
18-1. Change lever
18-2. Pointer
18-3. Lock button
19-1. Pointer
19-2. Change lever
Model
Carbide-tipped bit
Core bit
-1
)
Overall length
Net weight
Safety class
) : 92 dB(A)
pA
) : 103 dB(A)
WA
HR4001C
6.3 kg
ENE044-1
Uncertainty (K) : 3 dB(A)
Model HR4010C,HR4011C
Sound pressure level (L
ENF002-2
Sound power level (L
Uncertainty (K) : 3 dB(A)
Vibration
ENG905-1
The vibration total value (tri-axial vector sum) determined
according to EN60745:
Model HR4001C
Work mode : chiselling
Vibration emission (a
Uncertainty (K) : 2.0 m/s
4
19-3. Lock button
20-1. Depth gauge
20-2. Clamp screw
22-1. Blow-out bulb
24-1. Screws
25-1. Connector
25-2. Black
25-3. White
26-1. Change lever
26-2. Screw
26-3. Crank cap cover
27-1. Control plate
28-1. Screwdriver
28-2. Crank cap
29-1. Hammer grease
30-1. Connector
30-2. Black
30-3. White
HR4010C
40 mm
105 mm
235 - 480
1,350 - 2,750
468 mm
6.7 kg
/II
) : 90 dB(A)
pA
) : 101 dB(A)
WA
Wear ear protection
) : 10.5 m/s
h,CHeq
2
HR4011C
6.7 kg
ENG900-1
2