Service Note; Disc Removal Procedure If The Tray Cannot Be Ejected (Forced Ejection); Attention At Installation Of Harness (Dm-146) - Sony BDP-BX1 Service Manual

1-1.

DISC REMOVAL PROCEDURE IF THE TRAY CANNOT BE EJECTED (FORCED EJECTION)

1. Remove the upper case. (Refer to page 2-1)
2. Insert a clip in the hole of a drive and open a tray.
Note: Use a clip of about 1.2 mm in the diameter
1-2.

Attention at installation of harness (DM-146)

Push at Harness root.
SECTION 1

SERVICE NOTE

tray
Lead pin dressing method change.
From top side.
Upper case
Harness (DM-146) bending height.
Less than Heat-sink height.
1-1
BDP-BX1/S350
clip
(Use that of about 1.2 mm in the diameter)
hole
Need distance: Over 5 mm.
Actual: Around 12 mm after ben.