Set Up Using Wi-Fi Protected Setup - D-Link DMG-112A Quick Installation Manual

PRODUCT SETUP
SETUP
SET UP DMG-112A USING Wi-Fi PROTECTED SETUP (WPS)
NOTE: To connect to a wireless router or AP and extend the Wi-Fi network in your home,
please make sure the source router or AP features a WPS Push Button.
Push the WPS button on the source wireless router or AP, and then push the WPS button on
the DMG-112A. The middle white LED on the DMG-112A will start to flash.
Please allow up to two minutes for the configuration process to finish. Once configuration
between the DMG-112A and the router is complete, the white LEDs will light up to indicate
the strength of the signal between the DMG-112A and the router it is connected to. The
DMG-112A is now connected successfully and ready to share the extended Wi-Fi network
with your PCs and mobile devices. If the white LED does not turn on, you will need to repeat
the WPS setup process.
The SSID will be the same as the router that you are extending from.
8
DMG-112A