Table of Contents
Advertisement
(b) Reassembly
Disassembly procedures should be followed in the reverse order. Note the following points.
Apply grease on the sliding portions of the Pushing Lever [51], Sleeve [37] and Nose [26].
Insert the pointed end of the Hinge Pin [76].
Mount the Cover Spring [72] facing the longer arm side toward the Magazine Ass'y [77] as shown in Fig. 17.
Mount the Cover Spring [72] facing the
longer arm side toward the magazine.
11. INSPECTION AND CONFIRMATION AFTER REASSEMBLY
Check that Plunger (B) [60] and Trigger Plunger [66] move smoothly.
Check that there is no air leakage from each part.
While driving staples with an air pressure of 4.5 kgf/cm
bending of staples.
Note: Before conducting the driving test, turn the Adjuster [52] to the deepest position.
Recheck the tightening torque of each screw.
Check that Pushing Lever (A) [54] and Pushing Lever [51] slides smoothly.
Check that the machine will not operate only by actuating Trigger [67]. Also check that the machine will not
operate only by depressing Pushing Lever (A) [54].
Flat-blade
screwdriver
Cover Spring [72]
--- 25 ---
Magazine Cover [70]
Magazine Ass'y [77]
Hinge Pin [76]
Toward the magazine
Fig. 17
2
(63 psi), check that there is no idle driving and
Pull out.
Advertisement
Table of Contents
