Audio Component Hookups - Sony STR-DA80ES Operating Instructions Manual

Getting Started

Audio Component Hookups

Overview
This section describes how to connect your audio
components to the receiver. If you want to use the
receiver as an amplifier, complete these connections.
For digital connections, see "Digital Component
Hookups" on page 10.
S-LINK CTRL A1 IN
(USA and Canadian models only)
ANTENNA TV / DBS LD / DVD VIDEO 2 VIDEO 1
S VIDEO S VIDEO S VIDEO S VIDEO S VIDEO S VIDEO
LD
IN IN OUT IN OUT IN
DVD
AC-3 RF IN
LD
DVD
COAXIAL IN
FM
VIDEO VIDEO VIDEO VIDEO VIDEO VIDEO
75Ω
IN IN OUT IN OUT IN
COAXIAL
LD
DVD
OPTICAL IN
AM
AUDIO AUDIO AUDIO AUDIO AUDIO AUDIO
TV
IN IN OUT IN OUT IN
DBS
OPTICAL IN
y
CD
OPTICAL IN
DAT
MD
PHONO CD DAT / MD TAPE
y
OPTICAL IN
DAT
L
MD
OPTICAL OUT
SIGNAL
GND
R
DIGITAL
IN IN REC OUT IN REC OUT IN
PHONO CD DAT/MD
What cords will I need?
Audio cords (not supplied) (1 for each CD player and
turntable; 2 for each tape deck, DAT deck, or MD deck)
White (L)
Red (R)
Hookups
The arrow ç indicates signal flow.
CD player
Receiver
CD
L
R
IN
Tape deck
Receiver
TAPE
L
R
REC OUT IN
6
MONITOR
S-LINK
FRONT SPEAKERS
S VIDEO
CTRL A1 IMPEDANCE USE 4–16 Ω
OUT
IN
R B L R A L
AC OUTLET
+ + AC 120V 60Hz
SWITCHED 120W / 1A MAX
OUT IMPEDANCE
SELECTOR
4 Ω 8 Ω – –
L
R CENTER SPEAKER REAR SPEAKERS
R L
PRE OUT
FRONT REAR + +
CENTER
L L
WOOFER
R R
– –
IMPEDANCE USE 4–16 Ω IMPEDANCE USE 4–16 Ω
TAPE
White (L)
Red (R)
CD player
OUTPUT
LINE
L
Ç
R
Tape deck
OUTPUT INPUT
LINE LINE
Ç L
R
ç
DAT deck or MD deck
Receiver DAT deck or MD deck
DAT / MD
L
Ç
R
REC OUT IN
ç
Turntable
Receiver
PHONO
L
Ç
R
IN
If your turntable has an earth lead
To prevent hum, connect the earth lead to the y SIGNAL
GND terminal on the receiver.
CONTROL A1 Hookups (USA and Canadian
models only)
• If you have a CONTROL A1 compatible Sony CD player,
tape deck, or MD deck
Use a CONTROL A1 cord (not supplied) to connect the
S-LINK CTRL A1 jack on the CD player, tape deck, or MD
deck to the S-LINK CTRL A1 jack on the receiver. Refer
the separate manual "CONTROL-A1 Control System" and
the Operating Instructions supplied with your CD player,
tape deck, or MD deck for details.
• If you have a Sony CD changer with a COMMAND
MODE selector
If the CD changer's COMMAND MODE selector can be
switched between CD 1, CD 2, and CD 3, be sure to set the
command mode to "CD 1" and connect the changer to the
CD jacks on the receiver.
However, if you have a Sony CD changer with VIDEO
OUT jacks, set the command mode to "CD 2" and connect
the changer to the VIDEO 2 jacks on the receiver.
OUTPUT INPUT
LINE LINE
L
R
Turntable
OUTPUT
LINE
L
R