Disassembly And Reassembly Of The Driving Section, The Cap And The Magazine Section - Hitachi NR 83AA3 Technical Data And Service Manual

10-4. Disassembly and Reassembly of the Driving Section, the Cap and the Magazine Section

(1) Nose [32], Pushing Lever [45] and the related parts (See Fig. 19.)
Tool required
Hexagonal bar wrench (5 mm)
(a) Disassembly
Perform disassembly according to 10-2-(3) to remove the Nose [32], Pushing Lever [45] and the other
parts.
Remove the Nose Rubber [67] from the Nose [32] by stretching the Nose Rubber [67] with a thin rod.
(b) Reassembly
Disassembly procedures should be followed in the reverse order. Note the following points.
Be careful of the mounting direction of the Nose Rubber [67]. Mount the Nose Rubber [67] aligning with the
shape of the Nose [32].
Hook the Spring [44] in the 3 mm dia. hole of the Nose [32] aligning with the shape of the Pushing Lever
[45]. (The Nose [32] has two 3 mm dia. holes, one is for hooking the Spring [44] and the other is for the
depth adjustment pushing lever kit (optional accessory).)
Do not insert a roll pin into the other 3 mm dia. hole.
Nylock Hex. Socket
Hd. Bolt M8 x 22 [31]
Nose [32]
3 mm dia. hole
Fig. 19
Nose Rubber [67]
Spring [44]
Pushing Lever [45]
--- 32 ---