General Slideout Care - Winnebago 2011 Cambria Owner's Manual

SECTION 10 –
SLIDEOUT ROOMS AND LEVELING
1) Lift tab inside
protrusion on boot to
disengage motor brake
2) Disconnect motor
power lead from
wiring harness
Rear Slideout Motor/Gearbox Unit
(Located underneath rear bed)
-Typical View
3. Use a 3/4" socket and ratchet wrench on the
motor gearbox shaft to crank the room in.
4. Crank the room until it is just "snugged up."
Do not overcrank or you could damage the
gear assembly.
5. While maintaining pressure on ratchet
wrenches, re-engage the motor brake by
moving lever clockwise slightly (to right
when facing end of motor).
6. Reconnect motor power lead to wiring
harness.
7. Reinstall access panel (if equipped) and lower
bed board.
8. Fasten slideout room travel latching device (if
equipped) inside the coach before driving the
vehicle.
9. See your dealer for service of the slideout
mechanism before using again.
Further Information
See the slideout manufacturer's user guide
provided in your InfoCase for further instructions
and troubleshooting information.
10-8
3) Use 3/4"socket
on gearbox shaft to
crank room in

GENERAL SLIDEOUT CARE

• Wipe outer seals occasionally with talc or 303
brand protectant for smooth quiet operation.
• Clean the floors inside before retracting the
room to avoid floor scratches or carpet pile
snags.
• See your authorized dealer for regular
maintenance and service of the slideout
mechanism.