Table of Contents
Advertisement
Operating the Projector
Focusing and Positioning the Screen Image
Focusing and Positioning the Screen Image
When an image appears on the screen, check if it is in proper focus and fits well to the screen.
Zoom ring
To adjust the focus of the image, rotate the focus ring which is the outer ring on the lens.
To adjust the size of the image, rotate the zoom ring which is the inner ring on the lens.
To raise or lower the image on the screen, extend or retract two feet at the bottom of the projector
as below.
1.
Stand behind the projector and lift the foot adjuster levers while you support the front of the projector.
This unlocks the feet and can make them move freely. Take care not to drop the projector.
2.
While lifting the foot adjuster levers, raise or lower the projector until the screen image is positioned properly.
3.
Release the lever to lock the feet in their new position.
4.
To fine-tune the height of the projector, rotate the front feet to raise or lower it.
After raising the front feet, don't give impact on the upper side of the projector or press down strongly.
19
Focus ring
Advertisement
Table of Contents
