Brother DCP-L5600DN User Manual page 647

Level 1
Wired LAN
(For network models)
WLAN
(For wireless network
models)
Level 2 Level 3
Wired Status -
MAC Address -
Set to -
Default
Wired Enable -
(For wireless
network models)
TCP/IP BOOT Method
IP Address
Subnet Mask
Gateway
Node Name
WINS
Configuration
WINS Server
DNS Server
APIPA
IPv6
Setup Wizard -
WLAN -
Assistant
WPS -
WPS w/ PIN -
Code
WLAN Status Status
Signal
SSID
Comm. Mode
Level 4 Descriptions
- View the current wired status.
- View the machine's MAC
address.
- Restore the wired network
settings to the factory settings.
- Turn the Wired LAN on or off
manually.
IP Boot Select the BOOT method that
Tries best suits your needs.
- Enter the IP address.
- Enter the Subnet mask.
- Enter the Gateway address.
- Enter the Node name.
(up to 32 characters)
- Select the WINS configuration
mode.
Primary Specify the IP address of the
primary WINS server.
Secondary Specify the IP address of the
secondary WINS server.
Primary Specify the IP address of the
primary DNS server.
Secondary Specify the IP address of the
secondary DNS server.
- Set the machine to allocate the
IP address from the link-local
address range automatically.
- Turn the IPv6 protocol on or off.
To use the IPv6 protocol, go to
the Brother Solutions Center at
support.brother.com
information.
- Configure the wireless network
settings using the setup wizard.
- Configure your wireless network
settings using the Brother CD-
ROM.
- Configure your wireless network
settings using the one-button
push method.
- Configure your wireless network
settings using WPS with a PIN.
- View the current wireless
network status.
- View the current wireless
network signal strength.
- View the current SSID.
- View the current Communication
Mode.
for more
640