Troubleshooting - LENCO PA-95 User Manual

Mode
USB
SD
AUX IN
Bluetooth

TROUBLESHOOTING

Troubles
Power Indicator OFF
and NO sound
coming out
Power Indicator ON
But NO sound coming
out
Sound coming out
with NOISES
Gear whines when
using the
microphones
Treble and Bass are
no loud enough
If the speaker still out of work after checking with the above troubleshooting, please ask qualified service
centers to check and repair it. DO NOT attempt to service the system beyond that specified in this
operation instructions. All servicing should be referred to qualified service centers.
ACCESSORY
1. ONE speaker
2. ONE power cord
3. ONE wired microphone
4. ONE user's manual
This product operates at 2400 - 2483.5 MHz and is designated only to be used inside a normal
household environment. This product is suited for this purpose within all EU counties.
USB/SD Indicator
At Pause, it is ON;
At Play, it is Blink
At Pause, it is ON;
At Play, it is Blink
ON
OFF
Possible Reasons
1. AC Power Button is still OFF
2. Battery run out of power
1. Wrongly connect the RCA or
3.5mm Audio input.
2. Master Volume is in minimum.
Improper audio-cable connections
or cross talk
1. The MIC Volume is too loud.
2. The microphones are close to
the speaker
The Treble and Bass volume are in
minimum
AUX IN/BT Indicator
Trouble Shootings
1. Turn the AC Power Button to ON.
2. Connect the power cord to AC
220V/50Hz outlet to test if speaker still
working and to re-charge the battery.
1. Turn OFF the speaker and check all
audio cable connections.
2. Turn on the master volume to your
wanted level.
1. Turn OFF the speaker and check all
audio cable connections to see if they
are correctly connected.
2. If all cables are well connected, that
might be caused by some external
cross talks from your audio equipment,
you can turn down the volume to solve
it.
1. Turn down the MIC Volume
2. Keep the microphones at least 2
meters away from the speaker
Turn on both Treble and Bass volume to
your wanted level
9
OFF
OFF
ON
Blink