Sony cmt-bx50bt Operating Instructions Manual page 27

The sound skips or fluctuates, or the
connection is lost.
 The system and the Bluetooth device
are too far apart.
 If there are obstacles between the
system and your Bluetooth device,
remove or avoid the obstacles.
 If there is equipment that generates
electromagnetic radiation, such as a
wireless LAN, other Bluetooth device,
or a microwave oven nearby, move
them away.
The sound of your Bluetooth device
cannot be heard on this system.
 Turn up the volume on your Bluetooth
device first, and then adjust the volume
using VOLUME +/ (or VOL +/ on

the unit) .
Severe hum or noise
 If there are obstacles between the
system and your Bluetooth device,
remove or avoid the obstacles.
 If there is equipment that generates
electromagnetic radiation, such as a
wireless LAN, other Bluetooth device,
or a microwave oven nearby, move
them away.
 Turn down the volume of the
connected Bluetooth device.
The sound from the Bluetooth
headphones is distorted.
 Turn down the volume of the system
using VOLUME  (or VOL  on the

unit) . If your headphones have a
volume control, also adjust the volume
using the headphone's volume control.
 Press DSGX 
on the unit repeatedly
until "DSGX OFF" appears.

 Press EQ
repeatedly to select
"BASS" or "TREBLE, " and then press


repeatedly to turn down the
level.
Tuner
Severe hum or noise, or stations
cannot be received. ("TUNED" or
"STEREO" flashes on the display.)
 Connect the antenna properly.
 Find a location and an orientation that
provide good reception, and then set
up the antenna again.
 Keep the antennas away from the
speaker cords and the power cord to
avoid picking up noise.
 Connect a commercially available
external antenna.
 Consult your nearest Sony dealer if the
supplied AM antenna has come off the
plastic stand.
 Turn off nearby electrical equipment.
To change the AM tuning interval
The AM tuning interval is factory-preset
to 9 kHz (or 10 kHz, for some areas).
Use buttons on the unit to change the
AM tuning interval.
1
Tune in any AM station, and then
turn off the system.
2
While holding down ENTER

/
.
All the AM preset stations are erased.
To reset the interval to the factory
preset, repeat the procedure.

, press


Continued
GB