Components Within Cabinet; Removal Of Front Cabinet Brackets; Removal Of Door Grabber Assembly - Fisher & Paykel DEGX1 Service Manual

7.6

Components Within Cabinet

(a) Follow instructions for removal of the top deck. (Refer to
Section 7.4.2)
(b) Remove the two screws securing the top of the front panel.
(c) Spread the top sides of the front panel to clear the tabs on
the door grabber assembly.
(d) Pull the cabinet front forward and lift the base clear of the
feet.
(e) Disconnect the cabinet front earth wire from the chassis
and lift the cabinet front clear.
Reassembly
(a) Refit in reverse manner.
7.7

Removal of Front Cabinet Brackets

(a) Follow general servicing instructions for components within the cabinet. (Refer to Section 7.6)
(b) Invert the cabinet front.
(c) Remove the screw securing the bracket to the cabinet front.
(d) Prise the retaining clip upwards.
(e) Slide the bracket inwards then to the rear to clear the cabinet
front.
Reassembly
(a) Refit in reverse manner.
7.8

Removal of Door Grabber Assembly

(a) Follow general servicing instructions for components within the cabinet. (Refer to Section 7.6)
(b) Close the drum door completely.
(c) Disconnect the wiring from the door grabber
actuator at the sensor module.
(d) Push the tabs in on the rear of the left and
right hand grabber housings and lift the
assembly upwards and outwards.
Reassembly
(a) Refit in reverse manner.
Push Tabs
40