How To Feed With The Bypass Mode - Canon DR-2580C Service Manual

Note
• If the paper feed operation stops due to a system error or a paper jam while
the scanner is scanning, resolve the problem, make sure that the scanned
image of the last page that was fed has been stored, and then resume the
scanning operation.
• Note that documents that are printed on thin paper may fall out of the
Document Eject Tray.
• After you finish scanning, close the Document Feed Tray and the
Document Eject Tray Extension to prevent damage to the scanner while it
is not being used.

How to Feed with the Bypass Mode

1
Move the Feed Selection Lever to the nonseparated document (
2
Place the document into the Document Feed Tray one sheet at a time, so that
it touches the stoppers, and adjust the position of the Document Guides.
3
Start scanning from the application.
) side.
53
Using the Scanner