Across The Sewing Direction - Pfaff 3811-2/45 Instruction Manual

Note: The bearing disc 1 (fig. 1) is provided with four holes so that the machine can be set at the
required needle bar position.
After positioning the needle bar (handwheel) insert the cylindrical pin 2 into the desired hole
so that it sticks securely in the recess behind the bearing disc, thus ensuring that the
selected setting is fixed.
Note: For the following adjustment it is recommended to:
- remove the presser foot
- insert a new needle.
.1 Loosen screws 4 and 5 (fig. 4).
.2 Move the needle bar frame 6 (fig. 3) in accordance with the requirement.
.3 Tighten screws 4 and 5 (fig. 4).
Requirement:
.1 Loosen screws 4 and 5 (fig. 4).
.2 Swivel the needle bar frame 6 (fig. 3) in accordance with the requirement.
.3 Tighten screws 5 and 7 (fig. 4).
Bi14-01
16
The needle 3 (fig. 2) should enter the middle of the needle hole across the
sewing direction.
Clearance between the needle 3 (fig. 2) and the front edge of the needle hole
should be approx. 0.8 mm.