How To Clean The Filter; Feature And Technical Explanation; Feature Of The Washing Machine; Water Current To Adjust The Unbalanced Load - Daewoo DWF-100B Service Manual

How To Clean The Filter

CLEANING THE LINT FILTER
1 2
Pull the Filter frame Turn the lint filter
upward. inside out, wash to
the lint off with water.
Lint Filter
CLEANING THE WATER INLET FILTER
• Clean the filter when water leaks from, the water inlet.
1 2
Pull the Turn off the
power plug water supply
out before to the washer
cleaning it. and sperate the
CLEANING THE DRAIN FILTER
• In case "U" shape drain hose, this filter's equipped at the cack side of washer.
• This drain filter is to screen the foreign stuffs such as threads, coins, pins, buttons etc ...
• If the drain filter is not cleaned at proper time (every 10 times of use), Drain problem could be caused.
1 2
Put down the Turn the cap counter
remained water in the clockwise.
hose. And put a container
under the filter to collect
water.
CONTAINER
FILTER
4 5
Clean the drain filter Put in the filter along the
removing the foreign guiding prominence of the
stuffs. case. Please note the left
position of the filter adjusting
FILTER
the groove to the guide rib.
CAP
FILTER
CAP
10 CONVENIENCE
3
Return the filter as it was, and
insert the filter frame into the
slot.
Filter Frame
3
Pull the 4 Remove the dirt
inlet filter out.
from the inlet filter
with a brush.
3
Pull out the filter assembly off
the case of the main body.
SLIT
FILTER
CASE
CAP
CAP
6
Turn the cap clockwise tightly.
CASE
CAP
GUIDE
RIB
SLIT

6. FEATURE AND TECHNICAL EXPLANATION

Feature of the Washing Machine

1 The first air bubble washing system in the world.
2 Quiet washing through the innovational low-noise design.
3 The wash effectiveness is much more enhanced because of the air bubble washing system.
4 The laundry detergent dissolves well in water because of the air bubble washing system.
5 The adoption of the water currents to adjust the unbalanced load.
6 One-touch operation system.

Water Current to Adjust the Unbalanced Load

It is a function to prevent eccentricity of the clothes after wash by rotating pulsator C.W and C.C.W for 35
seconds.(But, the SUIT course have no operation of the water currents to adjust the unbalnced load.)
EFFECT
It reduces vibration and noise effectively while spinning.
WATER FLOW
WASH DRAIN SPIN FILL RINSE 1
MOTOR C.W
SINGAL C.C.W
TIME(SEC.) 0.3 0.3 0.3

Function for Soak Wash

DISPLAY THE RESIDUAL TIME
When the SOAK WASH is selected, the total wash time increases because 60 minutes for soak process are added
to the time of main process.
PROGRESS
SOAK PROCESS
FILL WASH STOP WASH STOP
• 2' 28' 2' 28'
60 Minute
NOTES ' ' mark indicates the operation of the water currents to adjust the unbalanced load.

Automatic Water Supply System For Blanket Wash

The water level would be lowered because the blanket absorbs water at the beginning of washing. Therefore, after
30 seconds, the operation is interrupted to check the water level, and then the water is supplied again until the select-
ed water level is reached.
DRAIN SPIN FILL RINSE 2 DRAIN
0.3 0.3 0.3 •••••••
35 SEC. (About 29 Times)
MAIN PROCESS
EXPLANATION
•••
11