Information From Isp - Atlantis Land Network Router User Manual

I-Fly Wireless Router ADSL
IP addresses for
distribution to PCs

3.4 Information from ISP

Before beginning the configuration of the Router you have to know the parameters of your subscription
ADSL.
There are five ways ― PPPoE, PPPoA, RFC1483 routed, IPoA, RFC1483 Bridge― for the device to
have a public IP address and then to access Internet. You have to check with your ISP about which way is
adopted.
VPI/VCI: Consult the telephone company to get the Virtual Path Identifier (VPI) and Virtual Channel
Identifier (VCI) numbers. The valid range for the VPI is 0 to 255 and for the VCI is 32 to 65535. The
default value VPI is 0 and VCI is 32.
For BT (VPI=0, VCI=38) and for KC ((VPI=1, VCI=50).
NAT: The NAT feature allows multiple-user Internet access for the cost of a single IP account. If you
need to have a public server or a public network, NAT has to be disabled.
Encapsulation Method: Be sure to use the encapsulation method (LLC/SNAP or VC MUX) required by
your ISP.
Gather the information as illustrated in the following table and keep it for reference. Before start
configuring this device, you have to check what kind of service is provided by your ISP, including the
following:
1. PPPoE VC-Mux
2. PPPoE LLC
3. PPPoE None
4. PPPoA VC-Mux
5. PPPoA LLC
6. 1483 Bridged IP VC-Mux
7. 1483 Bridged IP LLC
8. 1483 Routed IP VC-Mux
9. 1483 Routed IP LLC
10. Classical IP over ATM
11. Native ATM
Gather the information as illustrated in the following table and keep it for reference.
28
12 IP addresses continuing from 10.0.0.4
through 10.0.0.15
(Actually, it can support up to 253 users.)