Name And Function Of Parts; Front View; Front View (Panel Removed) - Sony PWS-100 Operation Manual

Name and Function of Parts

Front View

a On/Standby button and indicator
Switches the unit on/off (standby state). Connecting the
power cord places the unit in standby state, and the
indicator turns on red. Pressing the On/Standby button
while in standby state turns on the unit and the indicator
turns on green. Pressing and holding the On/Standby
button for two seconds switches the unit to standby state,
and the indicator changes to red. To turn the unit on again
after switching from On state to standby state, when the
indicator is red, press and hold the On/Standby switch for
three seconds or longer. The indicator goes out when the
power cord is disconnected.
b SYSTEM indicator
Indicates the status of the unit.
Green: Operating normally
Flashing green (once per second): System is
booting.
Flashing orange (once per second): A warning has
been generated.
High-speed flashing read (four times per
second): An error has occurred.

Front View (Panel Removed)

When the SYSTEM indicator or web GUI menu indicates
an error, you can remove the front panel to check the status
of the hardware components.
16
Name and Function of Parts
1 2 3
5
1 1 2 3
4
c ACCESS indicator
(When PWSK-102 units are installed) Indicates the access
status to storage.
If a packaged product, such as the PWS-100TD1,
PWS-100MG1, or PWS-100PR1, was purchased, refer to
the operation manual supplied with each packaged
product.
Off: Not accessing storage
Blue: Accessing storage
d Front panel LED
Turns on according to settings in the web GUI menu.
e USB connectors (front panel)
Connects to USB devices.
Note
• Both USB ports on the front panel support power
delivery (900 mA).
• Use SuperSpeed USB cables.
To remove the front panel, loosen the screws on the left
and right sides and pull the panel towards you.
4