Exmark Turf Tracer HP Operator's Manual page 20

For Exmark Mower Parts Call 606-678-9623 or 606-561-4983
3.9 Route the throttle cable along the right side of the upper handle, under the fuel tank
support, and position the cable on the left side of the engine.
Attach throttle cable to engine:
a) Position the throttle control lever (located on console) ¼" (6mm) from the upper end
b) Attach inner wire of the throttle cable to the top hole in the throttle control lever as
c) Loosen the clamp, place the cable behind it and pull on the cable to move the
3.10
3.11
of the slot.
shown in Figure 2.
throttle linkage to the full throttle position. Tighten the cable clamp screw.
(THROTTLE CABLE HOOK-UP)
Connect the blade engagement linkages (See Fig. 3). Loosen jam nut and remove
turnbuckle from lower linkage. Screw turnbuckle onto both upper and lower linkages
simultaneously. Note that threads on upper linkage are left hand. See 5.2.2 for
linkage adjustment.
Note: The standard pistol grip handles have the drive lever linkage on the
outside of the blade engagement lever tab and the hairpin on the inside. ECS
handles have the drive lever linkage on the inside of the blade engagement
lever tab and the hairpin on the outside.
BLADE ENGAGEMENT LINKAGE
Install the speed control rod assembly (linkage with the yoke installed on one end)
into the end of the speed control lever located underneath the center of the console.
Insert the end of the linkage (opposite the yoke) into the end of the speed control
lever from the right hand side and fasten with a hairpin from the bolt bag.
www.mymowerparts.com
FIGURE 2
SPEED CONTROL
FIGURE 3
- 15 -