Main wash water
You can select the type of water for
the main wash. Hot water can only be
only taken in if the wash temperature
is above 30°C.
This setting is confirmed when the
machine is commissioned.
If the machine is not connected to a
hot water supply, program durations
will be longer.
Rinse water
You can select type of water for the
final rinse. Hot water can only be only
used if the wash temperature is
above 50°C.
The machine is delivered with the Cold
water option selected.
Settings/Supervisor level menu
Low water pressure
This setting can be activated to
ensure problem free water intake
where the water pressure is
constantly low (below 100 kPa).
The machine is delivered with the No
option activated.
MOPS pre-spin
Wet mops can be pre-spun at the
beginning of the Mops program to
eliminate excess water.
The machine is delivered with this
option activated.
MOPS final spin
The speed of the final spin in the
Mops program can be limited (Low)
to give them a high residual moisture
level when they are removed from the
machine.
The machine is delivered with the High
option activated (for less residual
moisture).
47