Mobile Home Installations - New Buck Corporation 20 Room Heater Installation And Operation Manual

Buck stove room heater

Hide thumbs

Table Of Contents

Table of Contents

SECTION II

Listed NEW BUCK CORP.

Model

ZC20

UL Listed and Factory Approved Chimney Systems

Simpson Dura Vent

Security

Selkirk Metal Bestos

Metal Fab

CAUTION: Read through all of these instructions carefully. Follow approved Chimney Manufacturer's

Installation exactly. Failure to install the Cabinet Fireplace, Stove and Chimney as described in the instructions

will void the manufacturer's warranty and may have an effect on your Homeowner's Insurance. A major cause of

chimney related fires is failure to maintain required clearances (air spaces) to combustible materials. It is of utmost

importance that these parts be installed only in accordance with these instructions.

The Zero-Clearance cabinet and the Model 20 (hereafter referred to as the ZC20) is designed for installation in a

family dwelling, where minimum clearance is desired.

INSTALLATION PRECAUTIONS

The following precautions are mandatory for a safe installation:

A. Compliance with local building codes and regulations is mandatory.

B. Be careful not to damage unit in handling and unpacking component parts and accessories.

C. A UL Listed and Approved Chimney System is to be used and vented to the outside of the building. (See

chimney list above.)

D. The chimney must extend a minimum of 3' above the highest point where it penetrates the roof (3' above a

flat roof or up to 2 1/2 pitch roof), and the chimney must extend a minimum of 2' higher than any portion of

the building within 10' of the chimney. The minimum height is 12'. A 2" clearance must be maintained

between the chimney and any combustible materials at all points.

E. A rain cap must be used to terminate the chimney to prevent down-draft.