Table of Contents
Advertisement
2.3 The Rear Ports
1
2
3
4
5
6
2.4 Cabling
The most common problem is bad cabling or ADSL line. Make sure that all connected devices are
turned on. On the front of the product is a bank of LEDs. As a first check, verify that the LAN Link
and ADSL line LEDs are lit. If they are not, verify that you are using the proper cables.
PORT
Connect the supplied RJ-11 cable to this port
LINE
when connecting to the ADSL/telephone
network.
Connect a RS-232 cable to this port when
PS2(Console)
connecting to a PC's RS-232 port (9-pin serial
port).
Connect an UTP Ethernet cable to one of the
LAN
4X
four LAN ports when connecting to a PC or
(RJ-45
an office/home network of 10Mbps or
connector)
100Mbps.
After the device has turned on, press it to reset
the device or restore to factory default settings.
The operation is as below:
0-3 seconds: reset the device
Reset
3-6 seconds: no action
6 seconds or above: restore to factory default
settings (this is used when you can not login to
the router, e.g. forgot the password)
Connect the supplied power adapter to this
PWR
jack.
Power Switch
A Power ON/OFF switch
I-FLY WIRELESS ROUTER ADSL
MEANING
7
Advertisement
Table of Contents
