Table of Contents
Advertisement
SNMP CONFIGURATION
To set up SNMP (Simple Network Management Protocol), the SNMP communities
have to be set and access control to the SNMP server has to be enabled
Set Community
Get Community
Trap Community
Trap Server
Server Access
Secure Client
IP Address
Add/Delete
46
Type the SNMP community that allows the SNMP set command. You
can use SNMP software to configure the device such as System
Contact, Name, and Location.
Type the SNMP community that allows the SNMP get command. You
can use SNMP software to retrieve configuration information from the
device such as System description, Object ID, Up time, Name,
Location, and Service.
Type the SNMP community that allows the SNMP trap command.
When the device reboots, the device sends the trap to the trap
server.
Type the IP of the SNMP management center that should be
reported.
Options are:
Disable-No access from LAN or WAN
All- Access from LAN and WAN
(Note: This setting has no remote access restrictions; any IP address
will have access to the DFL-M510.)
WAN -Access from WAN only
LAN- Access from LAN only
The default option is Disable.
Options are All or Selected IP Address, which the SNMP
commands are restricted to come from.
Use Add/Delete to select IP addresses.
Advertisement
Table of Contents
