Tuning And Editing Channels; Manual Tuning; Retuning Channels - Panasonic VIERA TX-42A400E Operating Instructions Manual

Tuning and Editing
Channels
You can retune channels or make your favourite channel
lists, skip unwanted channels, etc.
[Setup] [Tuning Menu]*
* The menu name varies depending on the TV mode.
The settings in [Tuning Menu] are applicable only for
the selected TV mode.

Retuning channels

Only the selected mode is retuned. All the previous
tuning settings are erased.
1
Set [TV Selection] to the signal you want to tune
TV Selection
2
Select [Automatic Channel Search]
Automatic Channel Search
3
Select the provider (Cable only)
4
Set the settings for [Automatic Channel Search]
(Cable only) and start tuning
Automatic Channel Search
Scan
Scan Mode Advance
Frequency (kHz) 306000
Modulation
Symbol Rate (ksym/s)
Network ID
Scan
The function items vary depending on the country
you select. (p. 11)
[Scan Mode]
[Full]: Scans the whole frequency range. Settings
are made automatically. [Frequency] and [Network
ID] are not available.
[Quick]: Scans according to the settings you made
in [Network ID].
[Advance]: Scans according to the settings you
made in [Frequency] and [Network ID].
Normally set [Frequency] and [Network ID] to
[Auto].If [Auto] is not displayed or if necessary,
enter the value specified by your cable provider
with numeric buttons.
After settings, select [Scan].
Antenna
Access
0%
Auto
Auto
999

Manual Tuning

Analogue Manual Tuning
Set Analogue channel manually after [Automatic
Channel Search].
1
Enter the frequency to start scanning
Analogue Manual Tuning
Searching channels
Start Frequency (MHz)
Scan up
2
Select the scanning method
[Scan up]: Scans ascendingly from the entered
frequency to higher frequencies.
[Scan down]: Scans descendingly from the entered
frequency to lower frequencies.
DVB Manual Tuning
Normally use [Automatic Channel Search] or [Scan] to
retune DVB channels.
If tuning has not been done completely or for adjusting
the direction of the aerial, use this function.
All channels found will be added to the [Channel List].
DVB-C
1
Enter the frequency
DVB-C Manual Tuning
Scan
Frequency (kHz)
Auto
Modulation
Symbol Rate(ksym/s)
Signal Level
Signal Condition
2
Start scan
DVB-T
Select channel and start scan
DVB-T Manual Tuning
Scan
Channel 2
Signal Level
Signal Condition
48.00
Scan down
Cable
0%
306000
6875
0
0
Antenna
0%
0
0
English
21