Quick Start Guide - TeamBoard T4 The Quick Start Guide addresses some TeamBoard basics - from installation steps to screen calibration. This document assumes a basic understanding of your computer hardware and software. If you require more detailed information refer to TeamBoard.com or contact Technical Support.
To show Icons, A) Select Category, next to "View By." B) Click large or small icons. 5. Uncheck “Use flicks to perform common actions quickly and easily”. 3. Open “Pen and Touch”. 6. Click “OK” and close Control Panel. 1-800-263-2387 +1-905-851-2826 support@teamboard.com Register your TeamBoard T4 online at TeamBoard.com...
Quick Start Guide - TeamBoard T4 Installing MultiTouch Driver For Mac OS X When connected to a Mac OS X computer without a driver, TeamBoard T4 is a single-touch interactive whiteboard. To enable MultiTouch functionality, please follow the instructions below.
Calibration for Windows Filled TeamBoard Partially or Overfilled TeamBoard 4. If this is your first TeamBoard, skip to step 5. Otherwise, click If your projected image completely fills the TeamBoard without If your projected image does not completely fill the TeamBoard “Reset”.
If your projected image does not completely fill the TeamBoard overlapping the frame you will not need to calibrate the or it overfills the TeamBoard and overlaps the frame, please adjust your projector first. If this is not practical, please follow the TeamBoard.