Restoring The Default Password And Configuration Settings - NETGEAR WGR614v9 Setup Manual

Router Setup Manual
Table 2. Wireless Router Default Configuration Settings (continued)
Feature
Interface Specifications
LAN:
WAN:
Restoring the Default Password and Configuration
Settings
You can restore the factory default configuration settings that reset the router's user name to
admin, the password to password, and the IP address to 192.168.1.1.
This procedure will erase all the current configuration settings and restore the factory
defaults.
To restore the factory default configuration settings:
Use a sharp object such as a pen or a paper clip to press and hold the restore factory settings
1.
button, located on the rear panel of the router, for about 20 seconds, until the Test light begins
to blink (see "Router Back Panel" on page
Release the restore factory settings button, and wait for the router to restart, and for the Test
2.
light to turn off.
The factory default settings will be restored so that you can access the router from your Web
browser using the factory defaults.
28
Default Setting
10BASE-T or 100BASE-Tx, RJ-45
10BASE-T or 100BASE-Tx, RJ-45
4).
v1.0, July 2008
Default Configuration