Indoor Unit Connections - Conduit Bracket Placement - LG LS091HSV3 Installation Manual

REFRIGERANT PIPING CONNECTIONS

Indoor Unit Connections - Conduit Bracket Placement

Piping to Indoor Unit - Conduit Bracket Placement (HV3, HEV, HEV1)
1. Follow steps 1 through 6 on the previous page to connect piping to the rear of the indoor unit.
Most HV3, HEV, HEV1 and HXV single-zone models require an additional conduit "bracket/nut" to be installed
at the rear of the indoor unit to secure an elbow conduit. Follow the steps below for correct placement for your
unit model.
2. Set the conduit by using the bracket and "D" screws from the accessory kit. This must be done prior to
permanent placement of the piping to the rear of the unit, otherwise you won't be able to reach the conduit
once piping and drain hose are in place and anchored.
• For specific bracket placement, see each figure relating to the specific single-zone model.
Pay attention to bracket placement on each single zone units. Your model might be slightly different from gure shown in this manual.
For speci c bundling (taping) techniques of the Pipe and Drain Hose, see Section, "Bundling and Cutting Line" on page 45.
Figure 66: Installing Bracket for Conduit (HV3)
Figure 67: Installing Bracket for Conduit (090HEV, 090HEV1)
Bracket
Conduit
Nut
Conduit
Bracket
44
Type "D" Screws
Conduit Bracket
Type
"D" Screws
Due to our policy of continuous product innovation, some specifications may change without notification.
©LG Electronics U.S.A., Inc., Englewood Cliffs, NJ. All rights reserved. "LG" is a registered trademark of LG Corp.
Figure 68: Installing Bracket for Conduit (120HEV)
Bracket
Conduit
Nut
Type "D" Screws
Figure 69: Installing Bracket for Conduit (180HEV, 180HEV1, 240HEV,
240HEV1)
Bracket
Conduit
Nut
Type "D" Screws
Figure 70: Elbow Conduit
Conduit
Bracket
Conduit
Bracket