NETGEAR WG102 Reference Manual page 35

Reference Manual for the NETGEAR WG102 ProSafe 802.11g Wireless Access Point
Note: By default, WG102 is set to with the DHCP client disabled. If your network uses
dynamic IP addresses, you will need to change this setting.
Connect the power adapter to the wireless access point and plug the power adapter in to a
d.
power outlet. The PWR, LAN, and WLAN lights should light up.
4 V W
ERIFY IRELESS
Using a computer with an 802.11b or 802.11g wireless adapter with the correct wireless
settings needed to connect to the WG102 (SSID, WEP/WPA, MAC ACL, etc.), verify
connectivity by using a browser such as Netscape or Internet Explorer to browse the Internet,
or check for file and printer access on your network.
Note: If you are unable to connect, see
Basic Installation and Configuration
C
ONNECTIVITY
Chapter 6,
October 2004
"Troubleshooting."
3-10