Makita HP2032 Instruction Manual page 6

Hammer drilling
When drilling in concrete, granite, tile, etc.,
turn the action mode change lever to the
position of symbol.
Be sure to use
a
tungstencarbide tipped
bit
Drilling
When drilling in wood, metal or plastic
materials, turn the action mode change
lever to the position of
am
symbol.
Action mode change lever
For hammer drilling For drilling
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and unplugged before installing or removing
the side grip, bit or other accessories.
Side grip (auxiliary handle)
Always use the side grip to ensure operat-
ing safety. Install the side grip so that the
teeth on the grip fit in between the protru-
sions on the tool barrel.
Then tighten the grip by turning clockwise
at the desired position. It may be swung
360" so
as to be secured at any position.
Installing or removing drill bit
For HP2032
To install the bit, place it in the chuck as
far as it will go. Tighten the chuck by
hand. Place the chuck key in each of the
three holes and tighten clockwise. Be sure
tighten all three chuck holes evenly.
To remove the bit, turn the chuck key
counterclockwise in just one hole, then
loosen the chuck by hand.
After using the chuck key, be sure to return
to the original position.
7
Grip base
Tighten
6