Table of Contents
Advertisement
SAFETY INFORMATION
Continued
10. The installation and provisions for combustion and ventilation
air must conform with the National Fuel Gas Code, ANSI Z233.1/
NFPA 54, Section 5.3, Air for Combustion and Ventilation.
11. Do not run log set
• where flammable liquids or vapors are used or stored
• under dusty conditions
12. Do not burn solid fuel in the fireplace after installing the log
set. Do not use this log set to cook food or burn paper or
other objects.
13. Log set becomes very hot when in use. Keep children and adults
away from hot surface to avoid burns or clothing ignition. Log
set will remain hot for a time after shut-down. Allow surface
to cool before touching.
14. Carefully supervise young children when they are in the room
with log set.
15. When using a GA9050A-1 or GA9150A control system, do
not use this appliance if any part has been under water. Imme-
diately call a qualified service technician to inspect the appli-
ance and to replace any part of the control system and any gas
control which has been under water.
16. To help prevent breakage, new logs must be broken-in (see
Curing Logs, page 10).
17. Turn log set off and let cool before servicing, installing, or repair-
ing. Only a qualified service person should install, service, or re-
pair log set.
PRODUCT IDENTIFICATION
Grate
Burner
Burner
Pan
Clamp
Burner
Manifold
Figure 1 - Product Identification (BVDR24 Shown)
Hearth Kit Model ________________________
Serial Number __________________________
Log Set Model __________________________
901746-01D
LOCAL CODES
Install and use log set with care. Follow all local codes. In the absence
of local codes, use the latest edition of The National Fuel Gas Code
ANSI Z223.1/NFPA 54*.
*Available from:
UNPACKING
1. Remove logs, hearth kit, pan materials, and hardware from carton.
2. Remove all protective packaging applied to logs and base
3.
OPTIONAL PRODUCT
FEATURES
ON/OFF SAFETY VALVE/PILOT KIT AND
PROPANE/LP CONVERSION
Grate Steps
An optional valve/safety pilot kit with a piezo ignitor is available for
this appliance. This system requires no matches, batteries, or other
sources to light. You must use this optional system for LP conver-
sion. See Accessories, page 15.
REMOTE CONTROL READY (MILLIVOLT)
SAFETY VALVE/PILOT KIT
An optional millivolt valve/safety pilot kit with a piezo ignitor is
available for this appliance. This system requires no matches, batteries,
or other sources to light. This system may be connected to a wall switch
or hand-held wireless remote control. See Accessories, page 15.
Burner Inlet
REMOTE CONTROL ACCESSORIES
Fitting
There is an optional hand-held ON/OFF remote control that can be
purchased separately for this log set. You must use the millivolt
valve/safety pilot kit to use remote accessories with this appliance.
See Accessories, page 15.
A wall switch is also available for this appliance. You must use the
millivolt valve/safety pilot kit to use the wall switch with this
appliance. See Accessories, page 15.
SAFETY INFORMATION
PRODUCT IDENTIFICATION
OPTIONAL PRODUCT FEATURES
American National Standards Institute, Inc.
1430 Broadway
New York, NY 10018
National Fire Protection Association, Inc.
Batterymarch Park
Quincy, MA 02269
CAUTION: Do not remove the data plates from the
burner pan. The data plates contain important product
information.
for shipment.
Check all items for any shipping damage. If damaged, promptly
inform dealer where you bought the product.
3
LOCAL CODES
UNPACKING
Advertisement
Table of Contents
