Step 1: Assembling the Stand
Procedure
Place the stand leg with the tabletop plate facing down, and then place the caster on
top of the stand leg.
Place the caster on the stand leg so that the surface without a slit faces the attachment surface of the stand leg.
Tighten the bolts temporarily in the two locations on the top in the order of
Then, tighten the bolts temporarily in the two locations on the side.
Check that the attachment holes are lined up as shown in the figure, and then tighten the bolts on the
top temporarily.
Tighten
temporarily
Bolts: 4
Slit
Tabletop plate
Narrow
Wide
Tighten the bolt here first.
Caster
Stand leg
4. Assembly and Ink Filling
Caster
Attachment surface
Stand leg
,
.
9