NETGEAR WPN111 User Manual page 33

User Manual for the NETGEAR RangeMax™ Wireless USB 2.0 Adapter WPN111
2. Save your settings in a Profile.
a. Type a descriptive name in the "Profiles" field.
b. Click Save Profile. All the configuration settings are saved in this profile.
c. Click Apply.
d. Click Close to exit the configuration utility.
3. Configure the PC network settings.
a. Configure each PC with either a static IP address or with the IPX protocol.
Note: For instructions on configuring static IP addresses, refer to the networking tutorial
on your NETGEAR RangeMax™ Wireless USB 2.0 Adapter WPN111 Resource CD.
b. Restart the PCs.
4. Verify wireless connectivity between your peer devices.
Verify connectivity by using the Ping program:
a. On the Windows taskbar click the Start button, and then click Run.
Figure 4-2: Windows Run program dialog box
b. Assuming the target PC is configured with 192.168.0.1 as its IP address, type
192.168.0.1
c. This will cause a continuous ping to be sent to the device with the 192.168.0.1 static IP
address. The ping response should change to "reply."
C on figu ra tion
202-10076-01
and then click OK.
ping -t
4 -5